Skip to main content

Setup

We recommend you use anb_utils to communicate with your sensor. If you are using an alternative terminal program, please follow these instructions.

Set up Parameters​

Select speed = 57600
Data = 8bit
Parity = none
Stop bits = 1
flow control = none
All lines should be terminated with a CR.

The following splash screen will be displayed:

********************************************************************
                   ANB SENSORS
     Sensor Type                : AQ2_5m
     Interface Firmware Version : IB_20.0
     Driver Firmware Version    : STM_20.0
     System Serial Number       : 300239
     System Date (MM/DD/YY)     : 03/11/26
     System Time (24 Hour)      : 12:20:00
     Current Status             : Idle
     Deployment Mode            : Controlled
     Deployment Interface       : Terminal
     Modbus address             : 0x55
     Power                      : Always Powered
     Interval Delay             : 0 Minutes
     Fast Profiling Mode        : Disabled
     Immersion Sensor           : Enabled
     SD Card                    : Enabled
 ********************************************************************

Communicate with the sensor​

Type menu into the terminal to access all the Primary Menu of the sensor.


For further support please contact support@anbsensors.com