Skip to main content

Setup Screen

The Setup screen displays sensor information and the current operating status (e.g. Idle or Scanning) and provides controls for starting and stopping measurements.

The upper section of the screen displays information about the connected sensor, including:

  • Sensor serial number
  • Firmware revisions

This information may be requested by ANB Sensors technical support when diagnosing issues.

Start Measurements​

Press Start to begin sensor measurements using the currently configured settings.

Once started, the sensor status will change from Idle to Scanning.

Measurement results will then be displayed on the Main Page.

Stop Measurements​

Press Stop to stop sensor measurements.

The sensor will save any current results before returning to the Idle state.

note
  • Ensure the sensor is correctly connected before starting measurements.
  • Allow sufficient stabilisation time after deployment to achieve optimal measurement performance.
  • Configuration settings are retained within the sensor and are not affected by stopping measurements.

If you require further support please contact support@anbsensors.com