Connecting the Sensor

Once BMS setup is complete:

1. Ensure anb_utils is open in the Command Line Prompt window
2. Ensure the BMS is in the Sensor Detection Sequence, indicated by double beeps
3. Connect the sensor to the BMS, and the sensor will beep to indicate it has been powered
4. The BMS will stop beeping, and the splash screen will be displayed
5. Data will begin to stream in accordance to the pre-set measurement routine.

note

Sensor settings must be configured before connecting to the BMS. They cannot be changed whilst connected to the BMS.

For further support please contact support@anbsensors.com