Skip to main content

Sensing Modes

Test mode

Once set up, if you want to test the comms protocols without putting the sensor in solution:

  1. Do not abrade the transducer
  2. Ensure the immersion sensor is disabled, as described here
  3. Initiate measurement
  4. Once testing completed, reattach the SubConn protector

Deployment mode

  1. Use the Abrasion Block to abrade the surface of the installed transducer as shown here
  2. Ensure measurement parameters are set as required
  3. Ensure immersion sensor is enabled, as described here
  4. Once removed from the water, disconnect the sensor and dry completely
  5. Reattach the SubConn protector